ARC Owners manual 7/22/98 2:32 PM Page 5
Troubleshooting
If there is no sound fromIf the system plays at lowIf there is low bass output,
any of the speakers, checkvolumes but shuts off ascheck the following:
the following:volume is increased, check
the following:Y Make sure the polarity
Y Receiver/amplifier is on and(+ and �) of the left and
a source is playing.Y Check all wires and connec-right OSpeaker Inputs� are
Y Review proper operation oftions between receiver/connected properly.
your receiver/amplifier.amplifier and speakers.
Y Make sure all wires are con-If there is no sound from
If there is no sound comingnected. Make sure none of thethe center speaker, check
from one speaker, check thespeaker wires is frayed, cut,the following:
following:or punctured.Y Make sure that your receiv-
Y If more than one pair of
Y Check the OBalance� controlmain speakers is being used,erOs Center Channel Mode is in
on your receiver/amplifier.check the minimum imped-the �normalO or �wideO posi-
Y Check all wires and connec-ance requirements of yourtion. If it is in the �phantomO
tions between receiver/receiver/amplifier.position, the center speaker
amplifier and speakers.will not play.
Y Make sure all wires areY Check all connections
connected. Make sure none ofbetween processor/amplifier
the speaker wires is frayed,and the center speaker.
cut, or punctured. |